How to Swap Sleeves Between MYHIXEL I and II Devices
By MYHIXEL® | Men's Sexual Health: Last Longer & Better | Published: 2026-11-05
Category: Conseils et entretien
Match the sleeve to your exact MYHIXEL model, remove the old sleeve, clean and dry the device, then seat the new sleeve firmly. Keep the fit secure and avoid compatibility mistakes.
Quick answer
Always match the replacement sleeve to your exact device model: the MYHIXEL I sleeve fits only the MYHIXEL I device, and the MYHIXEL II sleeve fits only the MYHIXEL II. Remove the old sleeve, clean and dry the device, then seat the new sleeve firmly before use.
Why model-specific sleeves matter
The MYHIXEL I and MYHIXEL II use different internal geometries, so a sleeve designed for one will not seal or fit correctly on the other. Forcing a mismatched sleeve can cause air leaks, reduce suction, or damage the sleeve edge. Always check the product listing or packaging to confirm the sleeve matches your device model before ordering.
When to replace rather than swap
If you own both devices, you may be tempted to swap sleeves between them, but that is not recommended because each sleeve is molded for its specific device. Replace the sleeve when you notice tearing, loss of suction, or difficulty cleaning. Keeping a spare sleeve for each device avoids downtime.
Step-by-step sleeve swap
- Confirm your device model: Check the label on your device or its original packaging to identify whether you have a MYHIXEL I or MYHIXEL II. Then select the corresponding replacement sleeve. Ordering the wrong model is the most common mistake—double-check before purchasing.
- Remove the old sleeve: Gently pull the sleeve away from the device body, starting at the base. Avoid using sharp tools or excessive force that could scratch the device. If the sleeve is stuck, apply a few drops of water-based lubricant around the rim to help it slide off.
- Clean and dry the device: Wash the device with warm water and mild soap, then dry it completely with a lint-free cloth. Any moisture left behind can affect suction and promote bacteria growth. A dry device is essential for a secure seal—never skip this step.
- Seat the new sleeve: Align the sleeve's opening with the device's rim and press it down evenly around the circumference until it sits flush. Do not twist or stretch the sleeve during installation. An uneven seat causes air leaks; run your finger around the edge to confirm it is fully seated.
- Test the fit: Gently tug the sleeve to ensure it is secure, then use the device as normal. If you feel reduced suction or the sleeve slips, remove and reseat it. A properly seated sleeve should not move during use—if it does, recheck the model and seating.
Replacement sleeve options
- Sleeve Replacement - MYHIXEL I Device: Exclusively designed interior created by MYHIXEL's team of sexologists and technicians. This anatomical design is tailored to the MYHIXEL I device, so using the correct sleeve preserves the intended fit and sensation.
Sleeve Replacement - MYHIXEL I Device - Sleeve Replacement - MYHIXEL II Device: Anatomical design with high-end materials for a realistic penetration experience. The MYHIXEL II sleeve is built specifically for that device, ensuring a secure seal and consistent performance.
Sleeve Replacement - MYHIXEL II Device
